Construction: The Box of the table should be made up of 1mm thick “C” shaped CRCA sheet, bottom & back is welded to the “C” shaped boxes. Door should be made up of 1.2 mm thick CRCA sheet pivoted at ends with 4 mm diameter pins and have three lowers for ventilation. Powder Coated handle & magnetic latch to hold the door.    Top of the box & the top of the table is pop riveted & is made up of 304-grade stainless steel sheet having 24G thickness.  Three sides of both the tops are raised by 10mm, front side bend downward and four sides of both tops are bend & pressed to 1800   to avoid sharp edges. Framework : Square CRCA tube of 20 mm X 20 mm  X 1.2mm thick & two rods of 6mm dia is welded to back and both side which act as railing above the table box. Thelegs should have rubber shoes. Finish :  All components should be pretreated in separate eight tank process for better finish, good  adhesion  and corrosion protection.  Process includes Hot Degreasing, Derusting, Activation, Phosphating & No’s of Water rinses as per IS  3618 - 1966 class ‘C’ type and then pretreated  materials is coated with epoxy powder with film thickness of 60 microns (approx.) and then oven baked at 180 degree centigrade